Latest from my blog...

Subscribe to the RSS Feed

DIY – How to Install Crown Molding

Posted on 29 October 2018 by admin (0)

Want to give an elegant and sleek look to your home? A crown molding is the best option these days that will without a doubt add style and beauty to any area in your home. Installing a crown molding by yourself is a hard-hitting job and perhaps not for beginners as there are various edges, and you are working with long pieces overhead. Crown molding requires basic carpentry skills and lots of patience too so if you want to learn how to install crown molding by yourself? Here are some great tips to prepare you for installing molding on your own.

 

Here are simple instructions for install crown molding!

 

  1. Measure Walls where you want to install Crown Molding– The very first step to installing crown molding in your home is to start measuring walls by using a measuring tape to and add up the length of all the walls where you want to place it. Make sure to buy an adequate amount of material to represent cutting and fitting beforehand.

 

  1. Find and Mark Studs– We recommend you to use a stud finder to position and mark all the studs around the room. Position a piece of molding against the wall and ceiling to mark guidelines for the bottom edge.

 

  1. Consider Longest Wall to Begin Installation– The best way to install crown molding is to start installation on the most extended walls first. Here, because the divider is longer than the actual length of trim, we’ll have to join two pieces to finish the run in the end. To perform this task, we’ll utilize a scarf joint. A scarf joint is two restricting miters that cover.

 

  1. Fix with Scarf Joint – The primary piece ought to be cut square on the left and mitered on the right. A hand miter box and an electric miter saw can be utilized to complete this process.

 

  1. Tie up Molding at Stud Locations – To install, adjust the base edge to the reference lines and bang the square end into the divider. At that point, nail the embellishment at each stud area utilizing a pneumatic trim nailer, and a nail set. At the scarf joint, make sure the scarf arrives on a stud for firm support and secure. The abutting pieces are cut square on the right end with a turn around miter on the left.

 

  1. Apply Glue Joints – Apply wood glue to the joint, position it, and affix before nailing off whatever left of the piece. On the nearby walls, a piece of appropriate size needs to be installed which has an estimated length from one end to the other.

 

  1. Cope with the Inside Corners – Correct side will be butted, and the left will be an adapted miter. To make the adapted joint, miter the left end of the embellishment and after that back cut it with an adapting saw. Make sure to pursue the trims profile as a kind of perspective for the edge. At that point, document the rims clean, so the pattern slips flawlessly over the last piece; making an inside corner. Secure the portion and proceed with the way toward estimating, cutting and fitting as you work your way around the room.

 

  1. Miter Outside Corners – When we remain with the last piece, it is the outer edge. Outside edges have two contradicting miters. Cut the adjoining section, apply glue and fit.

 

  1. Finalize New Molding for Painting – Make beyond any doubt to top off all nail gaps with wood putty, caulk the seams and your new molding is ready to go for painting.

 

 

With these tips as mentioned above for installing crown molding by yourself, you shouldn’t have any troubles with the molding installation. Ensure to have sufficient time and do the crown molding task carefully, and by the time you know installing crown molding, it will add extra grace to your home.